You can click on the linked page to see all of our complete tandem axle brake line kits. You can select one for your trailer based on its length; we have kits for trailers from 15 to 30-feet. Some kits like # DM5429 use mostly steel lines but we also have kits that use all flexible lines such as # 20TA-BLKIT which can be a lot easier to install. view full answer...
I'll start out by saying that it's not that a trailer over 102" is going to be illegal, but it does require special permits in most cases; this will depend on the state laws where you reside. You are correct that with the configuration you're seeking it will be over that width and additional permits will be required for this trailer since you're going to be about 1" wider than the 102" limit, and there is not a wheel and tire combo that you can use to keep you under this. However, there... view full answer...
For a 90" complete slide topper kit you need the Solera RV Slide-Out Awning - 7'7" Wide - 48" Projection - White # LCV000163288. This is designed for slide outs 86" - 91" wide so if yours measures 90" then this is what you're needing. It comes with the awning, awning rail, hardware, and brackets for the installation. The only other thing you will need to pick up is a sealant like the Butyl Tape # 362BT-18x1-50 to help prevent leaks where you've installed the hardware.
Attached is a sample... view full answer...
I took a look at what we have for the Westin Molded, Lighted Running Boards # 27-0015, and the Replacement Lenses and Housings for Westin Molded, Lighted Running Boards # 27-9904 actually comes with a rubber seal pre-installed so there is not a rubber grommet for this.
If you also need replacement bulbs, you can use the Replacement Bulbs for Westin Molded, Lighted Step Boards # 27-9905.
If you're referring to something different, let me know and I'd be happy to see what we have. view full answer...
We do have universal lids like the MaxxAir UniMaxx Universal Replacement Lid for RV and Trailer Roof Vent # MA00-335001 which would work fine for any roof vent on the market today so you could use that, or if you wanted a direct replacement lid we could do that as well. I would just need the make and model of your roof vent and I can see if we have it.
Also, for the membrane the closest I was able to get to what you're needing was the Alpha Systems Superflex TPO RV Roof Membrane # AL78CV... view full answer...
The Furrion Chill HE Replacement RV Air Conditioner for Coleman Setup # FR42PV comes with a 6 pin to 9 pin wiring harness adapter. If your current Dometic AC system uses a 9 pin connection you will be able to connect the adapter that enables the Furrion unit to plug into your existing Dometic controller.
I attached a review video link below. view full answer...
Sure thing, take a look at the:
-Alpha Systems Superflex TPO RV Roof Membrane # AL62CV.
This product measures 45' long, 9-1/2' wide, and covers 427-1/2 sq.ft. view full answer...
I have a solution for you, but there is not a database that tells us what parts-like faucets and other items are used in 5th wheels, RVs and travel trailers; for this reason you're really going to be able to use whatever fits your personal tastes and matches the same installation method as your existing faucet for the kitchen in your 2018 Heartland Sundance.
With that said, I really like the LaSalle Bristol Utopia # 34427830001BNAF since it's got a pull down sprayer and has a nice, classy... view full answer...
I have a solution for your 2008 Fleetwood motorhome. The Andersen Camper Wheel Chock and Leveler # AM3604 will work with vehicles weighing up to 30,000-lbs and have up to 32" diameter tires.
These chock's are able to be customized to ensure a perfect fit, and can be trimmed up to 4".
This product also includes a lifetime warranty and is made proudly in the United States. view full answer...
Without knowing exactly which awning assembly you have-either 63" or 69"-there could be a number of parts that you might need. You can get just the pitch arm assembly with the Replacement Pitch Arm Assembly for Solera 69" Standard Flat Awning Support Arm - Black # LC375994 or Replacement Pitch Arm Assembly for Solera XL 63" Flat Awning Support Arm - Black # LC67VR. If you need the entire arm then you'll either need the Replacement Short Arm Assembly for RV Awnings - 63" Long - Black # LC404523... view full answer...
In order to find the correct replacement hinge for your 2018 Heartland RV Big Country 5W you're just going to need to measure your current hinge and note the type of hinge.
For instance, the replacement # PLR3408-PS is a strap hinge that measures 9-5/8" long, has a mounting bracket that measures 1-5/8" long x 4-1/2" wide, and has a 1/2" pin diameter.
Or if you're still not sure feel free to take some measurements and send a picture in and I'd be happy to help. view full answer...
I went ahead and checked out what we have for your 2018 Heartland RV Pioneer Travel Trailer, and the closest I was able to find is the:
-Low Profile LED RV Tail Light - Stop, Tail, Turn - 9 Diodes # RVSTLB60 for the passenger side, & the,
-Low Profile LED RV Tail Light w/ License Bracket # RVSTLB61 for the driver side.
These lights measure 8-11/16" long and 3-3/16" wide. view full answer...
For your 2018 Heartland RV Mallard Travel Trailer, you can use the Lippert High-Speed Power Stabilizer Jack - Black Waterproof Switch Kit - 30" Lift # LC298707, which is a direct replacement for your Lippert stabilizer 298707.
As far as the difference between the Lippert High-Speed Power Stabilizer Jack # LC369774 and the Lippert High-Speed Power Stabilizer Jack # LC298707 goes, the only real difference is the color of the controller. The Lippert # LC298707 has a black controller, and... view full answer...
The Replacement Hardware Pack for AirrForce 42" Hugger Style RV Ceiling Fan # 277-000408 comes with 12 fan blade screws and 1 pull chain for your 42" Hugger Style RV Ceiling Fan with Light Kit for RVs.
This kit will include all the hardware needed for your Replacement Blades for AirrForce 42" Hugger Style RV Ceiling Fan with Light # 277-000398. view full answer...
Yes, The Wiring and Safety Chain Extension Kit # PR34QR will work with your Hensley hitch per the manufacturer.
This kit will help you if your chains and cables do not extend 24 inches past the end of the hitch box. The working load of the chains is 15,800 pounds.
The 7-way extension that is included in this kit is 18 inches long.
I attached a review video link below. view full answer...
Per the manufacturer when it comes to the shear pins being broken you would have to replace the whole Lippert Jack # LC298707 because the shear pins are not replaceable, and there is no way to fix them.
What you will need to do is purchase a whole new # LC298707.
I attached a review video link below. view full answer...
From what I was able to find in my research, the 2014 Heartland Bighorn 5th Wheel has a GVWR of 14000-lbs, so you've likely already got 7k components on them. You should be able to change out the backing plates, hubs, and brakes on your trailer so you can upgrade to higher rated assemblies, but I do recommend checking a couple things on your tow vehicle first. It's possible that your weak braking is due to a wiring or brake controller issue on the vehicle; it could also be something as... view full answer...
In order to determine which air ride pin box like the Trailair Air Ride 5th Wheel Pin Box # LC179879 will fit your 2018 Cyclone 4200 Toy Hauler, you will need to find out which pin box you current have first.
To do this, you can first try and look for a product sticker on your current pin box that will have the pin box type on it. For instance # LC179879 is designed to replace Lippert 0719 pin boxes.
Or
If you're unable to find a sticker with this information on your pin box, you can... view full answer...
I have a solution for you, but you will need to measure the distance between the side frame stanchions on your trailer. Assuming that your trailer frame is between 22" and 72" wide, the Adjustable Width Trailer Hitch Receiver for RVs, 22" to 72" Wide # 13703 is likely going to be the best fit since it fits on box frame, I-beam and C channel frames. This hitch can be welded on or bolted directly to the frame and it has a 350-lbs tongue weight capacity, so it's going to be perfect for a cargo... view full answer...
For your 2014 Heartland Bighorn 3260EL 5th Wheel, I recommend the Adco Olefin HD All-Climate + Wind RV Cover for 5th Wheel Toy Hauler # AD69ZR.
This cover will fit RVs that measure up to 37' long, so it will work for your 2014 Heartland Bighorn, and will do great in the Arizona sunshine. view full answer...
Go To Results